![]() Sometimes search appears at the bottom of the list (and is thus hidden as there are more bins than slots in the window.) Given other parts problems this isn’t likely though. Which operating system? First suggestion (although from your other problems not likely), scroll down to the bottom of the parts panel window. Another option (since you used autoroute) is to select Routing->Select all traces then hit the delete key which will delete all the traces, then rerun autoroute and it should route again. ![]() In practice I sometimes can’t get a reconnection and end up deleting the wire and doing it again. If you click on the trace near the pin of the mini and drag it back a bit then back on to the pin, it should go green indicating the connection has re established. You now move the new part from the mine parts bin to the same position as the original (in all three views), but the connections will all be red (indicating no connection) in the mini. That deletes the mini, but leaves the traces. You can load this part in to your mine parts bin, then select the D1-mini in pcb and click on “delete minus”. It may work fine as is, I haven’t seen any complaints about hole sizes too small against this board, but here is an improved part that has proper size holes (and a few other fixes):
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |